This EUT is compliance with SAR for general
population/uncontrolled exposure limits in IC RSS-102 and
had been tested in accordance with the measurement methods
and procedures specified in IEEE 1528 and IEC 62209.
This equipment should be installed and operated with
minimum distance 0 mm between the radiator and your head.
This device and its antenna(s) must not be co-located or
operating in conjunction with any other antenna or
transmitter.
Cet appareil est conforme aux limites d'exposition DAS
incontrôlée pour la population générale de la norme
CNR-102 d'Industrie Canada et a été testé en conformité
avec les méthodes de mesure et procédures spécifiées dans
IEEE 1528 et IEC 62209.
Cet équipement doit être installé et utilisé avec une
distance minimale de 0 mm entre le radiateur et votre
tête. Cet appareil et sa ou ses antennes ne doivent pas
être co-localisés ou fonctionner en conjonction avec tout
autre antenne ou transmetteur.
été testé en conformité avec les méthodes de mesure et
procédures spécifiées dans IEEE 1528 et IEC 62209. Cet
équipement doit être installé et utilisé avec une distance
minimale de 0 mm entre le radiateur et votre tête. Cet
appareil et sa ou ses antennes ne doivent pas être
co-localisés ou fonctionner en conjonction avec tout autre
antenne ou transmetteur.
Changes or modifications not expressly approved by the
party responsible for compliance could void the user’s
authority to operate the equipment. This equipment has
been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential
installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference will not
occur in aparticular installation. If this equipment does
cause harmful interference to radio or television
reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following
measures:
-
Reorient or relocate the receiving antenna.
-
Increase the separation between the equipment and
receiver.
-
Connect the Equipment into an outlet on a circuit
different from that to which the receiver is connected.
-
Consult the dealer or an experienced radio/TV technician
for help.
This equipment complies with FCC radiation exposure limits
set forth for an uncontrolled environment. End user must
follow the specific operating instructions for satisfying
RF exposure compliance.
This transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter. The
portable device is designed to meet the requirements for
exposure to radio waves established by the Federal
Communications Commission (USA).
These requirements set a SAR limit of 1.6 W/kg averaged
over one gram of tissue. The highest SAR value reported
under this standard during product certification for use
when properly worn on the body is 0.919 W/kg.
Note: The manufacturer is not responsible for any radio or
tv interference caused by unauthorized modifications to
this equipment. Such modifications could void the user’s
authority to operate the equipment.